Superior Pump 92060 Sump Alarm System with 15-Foot Tethered Float Switch , Black

The media could not be loaded. I recently had a plumbing inspector request that I install an alarm for my basement bathroom's sewage ejector. Once again, I found it here on Amazon, where I could not find it at my local hardware store.This alarm works to notify a homeowner if the sewage ejector fails and water starts accumulating. The warning is triggered when the float rises from the water accumulation.I like that the instructions were straightforward and I did not have to hire a plumber to install.The setup required removing the ejector lid and clamping the float to the side pipe. I then made a new hole to run the wiring through to connect to the alarm. I also tightened the extra wiring with zip ties.I then plugged it in, hung it, and that was it!I tested the alarm and am very pleased about how easy this was to install, saving me money by not requiring a plumber.Overall very pleased with this order. It looks very well made, a great value, and I highly recommend it. Therefore I rate this product a five out of five stars.

Works good easy install

Took a few days to get the alarm It was very easy to install and it works great

It does it’s job but it’s way too loud, for us . Don’t get me wrong, it’s a good product, straight forward install but you practically need earplugs to get close enough to silence the alarm

Purchased to as a replacement for an installed alarm in my septic system. Straight forward replacement. Appears to be well made. Alarm is loud enough to be heard on another level of the house. Has 9 volt battery that is suppose to be replaced after the system alarms. Would buy again

Liked the simple installation. Came with stainless steel clamp and plastic clip to easily adjust float level. Alarm box must be mounted inside near a 120 v outlet . You will need some direct bury wire if your tank is outdoors. Float switch wire is 18 gauge. Alarm is quite loud.

I’ve only had this item for a couple weeks but it works and seems sturdy enough. I thought the price was reasonable.

The switch on our old alarm was a plunger type switch with no longer worked. I used this to replace it and it works fine. Basically a ball bearing in the switch which makes contact when the float goes horizontal. Make sure leave enough slack for that to occur. Easy to install. I cut the wire and spliced it into the existing wire that ran from the house. The alarm is so loud I can hear it from outside.

Simple hookup .

Works Perfect

Je suis satisfait de ce produit il fonctionne très bien mais 1 semaine après l’avoir acheté j’ai trouvé le même produit mais d’une marque québecoise à moitié prix sur le site internet de premiertech (rivière du loup) avoir su je l’aurais acheté directement d’eux…

The battery is a big plus. You don't 120 volts

I was having problems with septic pump not starting , this alerted me when tank was over filling and i was able to pump down using a switch i installed to bypass float switch till i corrected the problem