Ceality Glass Bed for CR-10S Pro, CR-X, CR-10 V2, Ender-3 Max, 310x320x4mm, Official Version Build Surface

My cr10 smart pro came and had a warped bed...no surprise there... Auto mesh couldn't compensate and all my prints looked like dog water... Enter in this glass bed... Flat as flat can be, mesh worked perfect and the adhesion...is beyond compare. Whatever they put on the glass is phenomenal at adhesion. With Pla and abs so far... Will update if PC or ASA does bad... But idk if I would put PETG on it as the adhesion might be too much.

Came quickly and it fit

I had tried every trick in the book to get my stock Snap Maker 2.0 A350 bed to be uniform and level across the bed, to no avail: heated cal, 11x11 points, heating then loosening/retightening heated platform screws, manual cal, dial guage cal, custom scripts, PTFE washer shims, copper tape shims, etc. It never gave me better than a ~200x200mm^2 surface that still wasn't perfect but at least adhered satisfactorily. Then, I bought this, did a 3x3 manual cal with the provided shim card and voila! Perfect prints from edge-to-edge. I only lose about 40 mm in the y-axis because the A350 is 320x350 and this plate is 320x310. I'll take that loss because it's so much better. I had to print custom remixed brackets because the ones on Thingiverse are for the 310x310 plate, but will post on Thingiverse. A+ product.

I've never particularly liked the flexible bed sheet that came with my printer, my preference is glass. This is the right glass bed for my creality machine. It has made my printing experience much better.

Pretty level and had texture on it so you don't need glue or tape to get prints to stick to it. It is slightly larger than my bed though by a few mm.

My original Creality bed was aluminum and sand paper. It was great at first but sometimes hard to get the print off and other times it would prematurely lift off the bed. The glass performs better than aluminum, is flatter and the chemical adhesive is great for adhesion as pore size is larger when heated and closes up when cool. You have to leave the bed at temperature your print or you print will release when it cools.I have only had one print so far that was hard to remove and left some material within the pores that I can not seem to remove but it hasn't been problem as adhesion is still good in those locations.

I have yet to have bed adhesion issues. Been running the bed at 65c using eSun PLA Pro. The bed is a hair too big (should have gotten the 310mmx310mm) instead, but it still fits. Parts stick like glue to the bed when hot, come off immediately when cooled. Very happy and totally worthwhile upgrade.

I’m actually an idiot and didn’t read the description well enough, this fits the CR-10S, not the CR-10 that I have! But that’s my fault not the sellers, and not the products. I ordered the correct version and it fits and works great, so this also gets a 5star since it’s the same product, just a hair larger