tonchean Adjustable Squat Barbell Rack 35.8"-65" Solid Steel Free Bench Press Rack Stands Dip Station Barbell Stand Multi-Function Weight Lifting Home Gym Fitness Portable Dumbbell Max Load 440 Lbs

It’s the typical made in China hardware. Self assembly with a 1 page instruction sheet, no verbiage, with an illustration. Make sure to use washers on both sides of each nut/bolt. Each bolt is the same size and screws into the nut with the plastic ring facing up to tighten. A 17 mm ratchet wrench with an extension and the included wrench helps speed up assembly. Also suggest a light film of silicone spray where parts are bolted together will help prevent rust. The stand crossbars/braces all bolt together, so there’s no welded joints holding the barbell/weights. Make sure not to over tighten the nuts during assembly- excessive pressure will bend the base and legs which are hollow metal pieces. During use the barbell squat rack (upper bar holders) wiggle, so don’t overload the weights. Make sure they’re on level ground and lift carefully on/off during use. I also use the rack for bench presses. Being separate units, it’s easier to move them around as needed. Some may complain they’re flimsy. I’m using it at home in my garage with a 60” (5ft) bar and I lift well below the reported 400 lb capacity of these racks. I wouldn’t want to try the max load. As they say- it is what it is and many similar and/or better racks were sold out on Amazon. During this crazy Covid time the racks definitely enable me to work out safely at home.

It's ok not very safe

Missing different parts.

There are zero instructions amd tons of piece just thrown in a box. Cost way too much for this. I honestly don’t even know if I’ll be able to put it together. I would not recommend. No reason something so simple should be so difficult it’s 2 bars like makes NO sense.

Horrible I'm trying my best not to send this back they sent me a repackaged item🤬