Halo MS180 180 Degree Replacement Motion Security Floodlight Sensor, Bronze

Installed this on the back deck, where the wife walks to the garage for her car. It didn't tale long to set it up so that the range and sensitivity were what we needed. It comes on within 2 steps of either the house or garage door, stays on for 2 minutes (which we want) but doesn't come on when the leaves are blowing off the trees. A cat can set it off, but thats ok. Works well, thank you

Really nice simple unit, direct replacement for my original one. Really simple to setup and seems to be of good quality. Most importantly the wires are a standard color black, white and red

I purchased this to replace an older Snap-It brand that is apparently out of business. It functions the same with the same wiring. The only thing experienced that threw me a curve was the Eaton has a Dusk-to-Dawn feature that causes the light to stay on at night. The instructions indicate in the trouble shooting section that in that situation, it is in the Dusk-to-Dawn mode, but nowhere else in the instructions is Dusk-to-Dawn mode mentioned let alone how to even get into that mode. I found that omission in the instructions a little disconcerting as it caused me a period of difficulty as the older Snap-It had no such feature although the units are essentially identical in looks. I didn't subtract a star for that but that is something Eaton should fix in their instructions because with some unknown sequence of operation of the switch, it activates the Dusk-to-Dawn feature although if it is in that mode, you turn it off for 40 seconds to exit that mode. Nice, but how does it get in that mode? I have no need for that Dusk-to-Dawn feature as the unit runs a relay and not the lights themselves and I have a manual switch that will turn them on or turn it off or turn the auto switch on for automatic function.

Mike from Ottawa, Ontario The Cooper Lighting MS180 appears to function as intended. However, one draw back is that you cannot set the sensitivity, because the device does NOT have this feature. Also keeping in mind that the instructions state that only one of these sensors can be used on one switch and I believe this to mean one circuit also. The red LED light ... technician stated that it will only function (blink) when something comes into the target area. That it the only time you will see this light illuminate. Pretty good 'bang' for your buck.

Sensor replacement took a bit of work but operates well once up. Great way to keep exiting motion detection LED light operational.