Zero Gravity Chair Replacement Fabric, Anti Gravity Lounge Chair Cloth with 4 PCS Replacement Lace Cords Gravity Chair Accessories Bungee Elastic Patio Recliner Chair (Upgrated Brown- 21")…

My old Zero-grav chair cover ripped when a visiting friend sat on it (I had no idea he weighed 350 pounds). I replaced it with an after-market cover that looked sturdy but soon began to come loose at the eyelets like the original one had done and I only weigh 150 pounds. Then I tried this cover - It's great so far. After over 2 years it is as good as new. Hints: When you put it on be sure to try to lace it exactly like the one being replaced, if possible. My chair's original cover had one more pair of eyelets than the after-market ones - I just started at the second pair of loops from the bottom. A pair of those spring clamps that woodworkers use (look like a giant metal clothespin) are really helpful to hold the bungee cords in place while you stretch the next section - do a little on one side then a little on the other until it's all laced up. I also had to drill out the rivet on one side of the back frame where it attaches to the seat frame and replace it with a nut-and-bolt so that I could slip the top of the cover over it (you also have to unbolt it from the armrest to get the cover past).

We replaced the fabric on 4 chairs and they are holding up nicely.

My swing’s fabric was sun warped and ripped. Two 21 inch and one 17 inch gravity chair replacement fabrics and my swing is fixed. Less than buying a new swing. One or two of the rivets started to break that is why 4 stars.

Chords to small for top and bottom, too early to tell about durability just put it on today, Material does look cheap, compared to original fabric.

was going to toss this chair but subjected myself to weaving 101 , glad i did chairs as good as new

I bought to fox my wicker chairs, I don’t have time to weave it and repair it. So I bought this and used zip ties to hold it. Works great especially not having to buy new chairs. Would recommend.

This was so much less expensive than buying a new zero gravity chair! Easy to install.

Once we used a hacksaw to remove the riveted connector it was smooth from there out. Laced up pretty well. Will need to be tightened up once it is used a bit. Had to buy a 5mm machine bolt and locking nut to replace the sawed off connector. But not bad for a curb find. This fabric was a bit wider than the original on the XL sized chair but it works nicely.