50 Caliber RacingSplit Collar Tube Clamp 1.5" I.D. For Fabricating Bolt on Accessories like Light Bar Racks, Harness Bars, Roll Cage Braces, etc! [FAB-100A3]

Excellent quality and fit. The wall thickness on these is atleast 3/8”. Others are maybe 1/8” or 3/16”.

Will work great for my 2013 Polaris rzr for the spare tire holder i'm building

Worked perfect for the hydro assist on my Jeep.Held onto the tie rod perfectly through several trails in Moab. I like that I can adjust it to compensate for tie rod angles.

I was very disappointed with this clamp, 4 of the 6 Allen bolts stripped out tightening it down, the thread holes on one side were not threaded all the way down the holes, and holes were not centered in half section. This clamp mite work for a light bar but was a total waste of time for a steering ram tie rod clamp. I would not recommend to anyone.

Arrived quickly. Good packaging. Was exactly as described and pictured.

Product as described

Machined non concentric, nearly 1/8 inch out of round. purchased to save time, will end up spending more time to correct out of round than it would to start from scratch.

After reading the other reviews I was hesitant to buy this, But I did anyway. Its garbage. The halfs dont match up and it does not properly fit over the tubing.