Impact Resistant Structural Adhesive, 07333, Two-Part Epoxy, True Automotive OEM Recommended, 200 mL/6.75 fl oz Cartridge, Purple

Amazing stuff from a good company. Glued on rocker panels on a car with this.

works great, very strong

great product

My father-in-law is a body mechanic he remodels very high-end cars when they get in wrecks he is the one that told me about this stuff if you are not used to using a product like this it can be a little overwhelming you have to make sure you are on complete level ground. Make sure that you can get something to the back side of the hole or where you're putting the body filler and make sure you can control where it's going if you're feeling a hole you need a little extra to come out that hole so it feels both sides and then put it in the hole but keep it in a controlled environment it takes a little while for it to set up but after it cures you better hope to God you did everything right because there's no change again when it dries. Biggest tip I can give take your time check two or three times before applying this product.

Nice product. Dries super hard and grindable/sandable. Made my old sloppy joints on my 66 Mustang look much cleaner after replacement of firewall and cowl. I used this in conjunction with welding but it makes a wonderful joint sealer after the panels are welded up even if not used between the panels. It says to only use resistance (spot) welding, but I used plug welding and avoided the area of weld holes with the adhesive because it does burn a bit and liquifies if it gets too hot. Clamp or screw the panels all around to get them flush then weld. I think it's stronger than just welds. You can see similar products in comparison with spot welding on youtube. It has incredible holding power. I just wish it cost less. For my firewall and cowl I needed a little more than one tube, so what remains will be used on the floor pans. You can use it pretty sparingly (a thin bead) if welding along with the adhesive, and don't try to mig weld through this stuff as it splatters and makes for a poor weld.