Generic Boulder 12' X 48inch ATS Easy-Build Steel Above Ground Swimming Pool Kit by WaterThat(WTECH1248)

Instructions are horrible ...if you're not mechanically inclined don't bother. We had to figure it out without Instructions. Very aggravating but nice pool once you're done. Good luck. My feet are killing me!!

My husband and I thought getting it level would be our biggest problem. Nope! With a 6ft level that’s pretty easy. We dug out our spot and removed any kind of vegetation. Put down 2,000 lbs of sand which got 2+ inches under the pool and a good earth mound. The directions for assembly leave something to be desired, the pictures are horrible and the directions packet vs the sheets of paper that come for each part say different things. Anyhow we got it assembled. When installing the liner I wore my most bendable soft no tread shoes, all cautions taken for no holes to be made. However when unrolling the liner I noticed a “stretch” mark on part of it. Something it came from the warehouse with, I figured it was ok since they shipped it like that. After filling it 2/3 of the way we noticed a small wet spot on the outside, I figured it was from where the hose dropped. When I came out in the morning the water level had dropped, sure enough the liner they shipped us was not fine. It will in-fact need replaced. It’s not a big hole in the liner by any means, it only went down less than half an inch in twelve hours. Still that stretch mark it was shipped with has a pinhole in it. We will patch it and use it this year and fix the liner next year. We didn’t receive the ladder in the picture, we received a all plastic one that is MUCH heavier. No big issue there I would have just preferred the pictured ladder as it’s lighter, I’m short and can’t move the heavy one they sent. All in all if the directions were a little more clear with better pictures and the liner wasn’t faulty we’d have no complaints. It is sturdy, looks good and w sure will serve us well.Update: May 2023It’s opening time and oh boy has this pool given us a run for our money this past year. The liner issue above was resolved, they sent a new one. The pump however never quiet seemed strong enough, the flow out of the jet is ok but never “strong”. The pump and filter are unable to support a vacuum, not one time have we been able to get the suction strong enough through the vacuum. We resorted to using a battery operated vacuum. This year opening, we read through the pump & filter directions, watched several videos to make sure we didn’t set anything up wrong. We did everything right, still not enough suction to vacuum the pool or the skimmer to even catch anything. The pool has been open for a week and a crack has appeared on the pump. Water shooting out everywhere. So now we are in position yo having to buy a new pump. All in all this seems to have been produced very cheaply. The pump sent wasn’t even the pump in the picture.