Flutesan 20 Pcs 5 Pin 12 mm LED Strip Connector RGB Lights Waterproof Adapter 22 Awg Wires Connector for Strip Light Unwired Gapless Track 5v 12v 24v

These things are amazing. I bought them to split my cords and have 2 short ones on our church stage. They work very well and we're easy to setup. Its only been a week. Will update if anything goes wrong.

For the les side, the end that meets up with this will need almost a whole pad- do not cut in center. Not sure how strong these are in regards to maintaining connectivity. Seems that a little mech. movement at that joint would compromise power. On the one I used, it seems tight.

I have zero experience as an electrician but I finally finished installing led lights into my library bookshelves and hooked them up to alexa. It was not an easy project but these connectors are sturdy and wont break. Lining up the strips with the metal claws was annoying at times, and I had to switch out led strips to get a more reliable connection.

Work as they should. Easy to use.

Stay away from these connectors. They are inconsistent in the application - meaning you will do it the exact same way and one strip will not have the correct colors because the metal piece didn't puncture the right area. And also think about that - it's puncturing your light strip. It's extremely difficult to install - extremely frustrating especially when doing multiple items, I don't think it's worth it in the long run. I'm almost finished with my project - I only have four more shelves out of a total of 24, and this was by far the worst experience of it. Unfortunately I don't have an alternative idea outside of soldering - but buyer beware with these!

I bought these connectors for an 8mm LED strip project, hoping to save time on soldering. While they do make a connection, I ran into two significant issues during installation. The "Thickness" Issue If you plan to use these inside aluminum LED channels with diffuser covers, be careful. The connector body is quite thick/tall. When I tried to snap the plastic diffuser cover back onto my channel, it hit the top of the connector and wouldn't close properly. I had to leave the cover off in those spots, which ruins the clean look. Wiring Difficulty I found these very difficult to use with solid core wires. The mechanism seems designed for stranded wire; solid wire is too stiff to manipulate into the connector easily and doesn't seem to seat as securely. Verdict These might work fine for "bare" LED strips where you have plenty of vertical clearance, but if you are using slim profile channels or working with solid wire, I would look for a lower-profile option or just solder your connections.

As expected

the best out of all i've tried

The teeth aren't strong enough to pierce the casing around the wires, so they don't make contact. Using pliers to add a bit of pressure does nothing, as the amount of pressure needed to pierce the wires only cracks the housing.