S&R Diamond Cutting Disc 125 x 22.2 mm Saw Blade for Angle Grinder universal use - Concrete, Stone, Brick, Masonry

Very impressed with the cutting ability. For the money I think it's the best masonry disk I've ever owned

Very good discs, nice clean straight cut, cuts with ease and no overheating or discs distortion.

Does a better than average job but still leaves small chips in tiles. I was disapointed as the reviews indicated it degraded with use however it was chipping from its very first use.

I had a large fencing job to do involving concrete posts and concrete gravel boards, and needed to purchase a diamond tipped cutting blade for my angle grinder. I had seen this particular cutting blade on Amazon and so ordered it not really knowing whether it would be up to the job or not. But I needn't have worried, this blade cut through 2 inch thick reinforced gravel boards with ease in just a few minutes. The blade was extremely good value, and whilst using it with my angle grinder gave an extremely clean straight cut. all in all I personally think that it is a very good diamond tip blade for an extremely good price.

Excellent blade so far, as good as rubi blades I have used. Using on a rubi table saw 250 for 2cm porcelain slabs. Has lasted the first 10 cuts so far

Works great

Good value for money.no problems

I used this for block paving ( concrete blocks 60mm depth) my drive . Previously I was cutting blocks with Carbide discs which although they cut blocks reasonably well they did wear down down very quickly . Cost of these was £6 for 3 discs . One carbide disc lasted for cutting about 50 blocks . I’ve cut 200 blocks with the diamond disc and it’s showing no sign of wear . ( it’s Still 230mm Diameter ) . Also it cuts so easily just like a knife through butter , unlike the carbide discs .its saving me so much time and money , paid for itself up to now and no sign of wear. No brainier not to buy it if you are cutting blocks , pavers etc .

Hab die Scheiben noch nicht im Einsatz gehabt, machen aber einen brauchbaren Eindruck.

Bra produkt

Die Diamanttrennscheibe 230 x 22,2 mm eignet sich sehr gut zum Schneiden von Steinen. Ich habe sie für verschiedene Arbeiten verwendet, zum Beispiel für Pflastersteine und Betonsteine, und die Scheibe schneidet sauber und zuverlässig. Die Schnitte sind präzise und die Scheibe arbeitet auch bei härteren Materialien ordentlich. In Kombination mit einem Winkelschleifer lässt sich damit gut und relativ schnell arbeiten. Auch nach mehreren Schnitten zeigt die Scheibe kaum Verschleiß.

Couper des carrelages

These are excellent long lasting blades that I use to cut agate,a little wider and a little slower than a MK Hotdog.You can go out and drop 50-60 $ on a blade that is dull in 3 cuts .Find they are a little tricky to sharpen,have tried a mill bastard, aluminum oxide stone ,at the moment a coarse silicon carbide wheel seems to work the best..Have yet to wear one out...