for Quest Pro Full Light Blocker,Silicone Facial Interface Magnetically attaches for VR Quest Pro Accessories

Just received mine today and tried it on briefly. It snaps right into place literally by itself which is great and it feels pretty comfortable wearing it however I haven't worn it for an extended amount of Time to see how the material holds up in regards to irritation etc I did notice that there is some light seeping through the bottom it's like a paper thin crack but after wearing it for about 30 minutes it seemed to have fixed itself perhaps it just had to mold a bit better and we'll see how that holds up as well. I'll report my findings if the product does not hold up but other than that I'm happy with the purchase so far.

Blocks light well, fits perfect, magnets are at a good strength to stay on and wont fight you when you want to remove them.

Works great at blocking out all the light its durability could use some improvement as the glue between the soft material and the hard frame has separated in some areas. It fits and installs perfectly on the headset and even fits ok with other third party parts. over all great upgrade to the quest pro headset for the cost.

It blocks out a lot of the light but it’s not properly fitted to the quest pro so there is leakage. It’s almost more distracting to have a slit of light along the bottom than having the blocker off completely. Like people say, it doesn’t charge with the blocker on but not really a big deal cause it magnetizes on and off. If it’s too inconvenient to take the blocker off every time you charge then maybe look for a different solution. That aspect didn’t really bother me though

Works perfect for the pro covers every light u just have to adjust it ti the right angle and it as breathing small holes so u dont suck ur eyes out like others

Works, but not well. Doesent fully block out light. There is still a lightring around the faceplate due to improper fitting.

The blocker works really well and is a lot more comfortable than the side blockers that came with my Pro. My only issue was that part of the rubber that should connect to the frame didn't seem to be glued properly so a little light would get through on my lower right side. A little electrical tape fixed it. No problem though, I'm still very happy with it.

The default eye blockers the quest has are dreadful, ordering this finally got me the immersion I needed, so much that i was afraid to stand up because I had lost sense of my room space haha. These would take out 95% of light by default with a slight light line visible at the nose due to how silly the quest straps are, and 100% if you fit your headset at the right angle for your head.