Parker R119-04CG Regulator, 0-125 psi Pressure Range, Gauge, 150 scfm, 1/2" NPT

Way nicer than cheapo foreign brands. You set this thing to a pressure and it never varies, dead accurate regardless of flow. Just no comparison to cheaper models.

Well made, less restrictive and more responsive than anything I have used in this class of regulatorUpdating this review; I have two of these, one of them appeared to have been installed prior to when I received it and sure enough it would creep and bleed off. I sent these folks a note and they immediately refunded my money so I ordered another and it was here the next day. New in the box and I have no doubt it will work as good as my other unit. Would by again no worries

This is an industrial strength regulatory that is much better to use and safer than the cheapo harbor freight it replaced. Very quality unit and I'm. Happy with it

Well made item used on my compressor. Works fine no leaks.

Very good, solid regulator. Has a high input pressure rating that can handle high PSI compressors and very firm and positive adjustment. Gauge included is a plus.

I don't want to wait for another regulator so I'm going to have to spend my own money and buy another gauge somewhere else. Very disappointed!

This is my first industrial-grade pressure regulator, and it is built worlds better than the consumer junk you get at the local big-box store. The consumer-grade ones I would go through one about every year and a half to 3 years, depending on use. every one of them failed in the same way, the diaphragm would slip out of the clamping edges. this is due to the fact that they have only a small amount of the rubber lip in the clamping area, and the regulator was assembled with only four screws. This parker has the rubber diaphragm going all the way to the edge, which increases the surface area of the clamping force, and they use 6 bolts to clamp the assembly together. I'm looking forward to many years of service.

Very nice regulator for higher pressure