W3000HC

Used for around 9 hours so far this week and hasn’t required any maintenance other than what you should do with any new engine (oil change+filter check). Unlike cheaper machines I’ve owned the engine hasn’t vibrated itself loose or thrown any parts off, no metal shavings in the oil after use which I found on both of my cheaper engines.The singular problem I had was with the small pre drilled hole for the screw that holds the 90bend exhaust tip on. It was a little bit small due to the thick layer of paint applied around the exhaust after drilling, 30 seconds with my drill just to clean the hole out and the screw went straight in. I would rather have thick paint and do this than have the paint flake off after first use. Or you could just not mount it at all as it wouldn’t effect the performance.Gun feels comfortable to hold and the trigger action is light so I got no hand ache when holding it for hours. I can’t comment on all the nozzle heads as I have only used 15 degree and detergent heads on this washer but these seem to stay put once clipped in.Taking an educated guess I’d say your looking around £1 an hour fuel cost. Not bad at all.The first time you start it, it may struggle with the choke on. After the first use, I found I can start it with the choke on as normal, every time, and just ease it off.I will also add that I was contact by email from Peter at Waspper after the order to say thank you, and again with a manual, you also get a paper manual in the box. Then he contacted me again to make sure I had received it and it was in good condition on arrival. Always responded with 24 hours so I have no concern that they wouldn’t get back to me if I had a problem and contacted them.

The Wassper unit arrived in packing that had burst open. Oil filling is awkward and needs a small tundish to accomplish. The poppets that retain the ‘ nozzle dashboard’ would have been better as screws.The unit is noisier in application than an electric washer. From first use it seems quite heavy on fuel.

Can't fault the machine at all. The machine arrived well packaged and in perfect condition. Very easy to set up and after putting the oil and petrol in, first pull and the engine started. Highly recommend using a small filler/funnel to get the oil in. I also purchased some different ends to make the lance to the hose all quick realise, but that was my choice. I have also purchased a 10m hose as I found the 7.5m that it comes with a little short.On the whole, fantastic machine at a great price.