Preparation: Steel/Aluminium: Degreasing with solvent or with a suitable detergent. Stainless Steel: sabbiare to grade sa 2 - Metal Surface almost white. If not possible sabbiare discare the metal with 24 - 36 grit discs up to obtain a uniform surface clean and engraved white metal with an average of 50 - 75 micron. LEAD: Degreasing with solvent or with a suitable detergent. 120 Grit Sanding well with paper of mechanical or use a brush. Thoroughly clean and to make sure that the surface is dry. pre-primerizzare using a primer International as indicated for specific pitturazione cycles. Aluminium: sabbiare with aluminium oxide sanding or however with FREE OF COPPER. If ï ¾ Not Possible sabbiare discare the metal with 24 - 36 grit discs up to obtain a uniform surface clean and engraved white metal with an average of 50 - 75 micron. Stainless Steel: sabbiare For Creating A profile of engraving of 50 micron diluted before applying a hand of Interprime 820 as anchor. VTR Nude: Clean with super cleaner, rinse with fresh water and leave to dry. Grade 80 sanding with abrasive paper. Remove all residues of sanding before proceeding. Epoxy Primer: sabbiare or abrasivare with 120 Â € "180 Grit Paper. Epoxy Stucchi: 60 - 120 GRADE sanding with abrasive paper. Do not wipe or rub, epoxy, with solvents. Method: remove all residues of sanding sanding or using compressed air clean and wiping clean with brushes or brushes; the suction with the industrial vacuum cleaner provides the best guarantee of residue-free removal. Apply to spray the number of hands specified on the card technique, respecting the intervals of covering between the hands. If applied directly on metal surfaces, Interprime 820 must be diluted with 15% yta910, yta920 and applied to wet thickness of 160 micron.
Trustpilot
2 weeks ago
2 months ago
