Thermal Grizzly - PhaseSheet PTM (50x40mm)- High Performance Thermal pad with Phase Change Material | Durable, not electrically Conductive | for CPU, GPU & Electronics Cooling

Incredibly difficult application, following all instructions including putting in freezer did not help, thermal pad was stuck to the plastic and was ruined by the time I got it out, stick with paste, this is not worth the hassle, I can get a regular paste application done in under a minute, but this took me an hour and still failed horribly.

Great stuff, it works quite well. A little tough to peel off the protective sheets thou. The trick I found was to peel off the harder to remove side first mostly to loosen it. Then peel the other side a bit at the opposite corner to loosen it and then you should be able to apply it without issues. I tested it against Arctic Silver 3 which is ancient and it was a lot better.

Los resultados son bestiales de asta 14° menos en una msi GF63 pero eso si fue algo difícil de poner pero dejándolo 5 minutos en el congelador ayuda bastante no importa que se rompa solo juntado y con el calor de la manos se une nuevamente

Decided to try this instead of Honeywell one because that one is difficult to find. In terms of application and ease of use it's pretty much the same as Honeywell. And I suppose performance wise as well because it's been quite some time since I applied it and my gaming laptop has not thermal throttled or even needed to ramp up fans a lot. Overall it's quieter, colder and stutter free. I highly recommend to ditch normal compounds and get this instead. Follow instructions carefully and remember to clean every part of your heatsink and cooling system properly because using this.

Listen, this stuff is great and easy to install (put it in the fridge for 2 hours, cut to size, peel off the film with tweezers and slap it down). The thermal performance was slightly better than Arctic MX-4 as I'm not using direct-to-die cooling, but I mainly bought this for the longevity. I must warn you, however, that if you do decide to replace your CPU cooler at some point like me, this stuff is not the soft flexible material that that it is pre-application. Once it's gone through some heat cycles it turns into CEMENT. Yanked my AM4 CPU right out of the socket even after running Prime95 for 30 mins prior to removal. I had to use a heat gun directly on the heatsink just to get the PhaseSheet soft enough to pry the CPU off. Thankfully no damage to the pins, but it's something to bare in mind. If you plan on keeping your CPU cooler for 5+ years, and want a very effective thermal solution where you never need to repaste, BUY THIS, IT'S GREAT. If you foresee yourself changing your CPU or CPU cooler anytime soon, STEER CLEAR.

It's quite expensive for the size you get. Put it in the fridge before trying to cut it into shape and then it'll be easy to cut into shape. It's not that easy to apply if you're cutting a custom size. It works very well, my temps went down by 10 degrees compared to high performance thermal paste. The size is as advertised.