Harvest Lane Honey Plastic Bee Hive Stand

It is very sturdy and balances perfectly. It arrived on time. It doesn't come with assembly instructions but I put it together using common sense and the photo on the box as a guide. Everything fits perfectly meaning there is no give. You have to use some pressure to push the frame pins all the way in. But once they are in, they are very secure. I was afraid that it was too narrow for my base to fit. But I was able to squeeze it in and make it fit. It is a very tight fit and then there are 4 screw holes to attach it to your base. It is probably good to have no give or wobble. It acts like one piece. I just wanted a very stable base that was higher than a couple wood pallets or cinder blocks. Also having only 4 points touch the ground lessens the chance of an invasion from slugs and other crawling insects. I put sticky material over the base of the legs to stop ants. I forgot when I order this that there is a tray to hold your frames on the side. That was a pleasant surprise.

Sturdy and will withstand the elements

Frame holders to short

Sturdy and so convenient to have the frame holders attached.

I received this hive support without instructions. Here's how to assemble it.1) Get some silicone spray lube - it makes the job much easier!2) Inspect the parts. The small sides "receive " the larger sides.3) The large sides slide into the smaller sides from the bottom up.4) Get a paper towel, fold it into a pad and spray the silicone onto the pad - Not Much!5. Wipe down one end of the long frame with the silicone on the paper towel.6) Carefully insert the long end into the small end UPSIDE DOWN, with the both stand's legs up.7) Push the long end in carefully and slowly until you hear a big *CLICK*. (You may have to wiggle it for the side to slide better.) That side is now locked in place.8 Put the two assembled pieces on the floor with the legs sticking up9) Find the other small side and using the silicone pad, wipe down the assembled large side's edge that will be insertPick up the assembled pieces and carefully insert the larger side into the smaller side until you hear a loud *CLICK.11) Now wipe down both edges of the remaining large side. You may have to respray your paper towel pad.12) Bring the smaller sides inwards and line up the larger side's inserts into the smaller side.13) I had to start one side in *not too far * and then start the other in.14) Once the sides are both started, press down or tap the large side down , ALL THE WAY, until you hear those *CLICKS*.15. To help support the stand, place the metal pieces in their respective holes. Again, use silicone to help them slide in, and later out, if need be.Done!

Too Wable and the frame pins are sticking out. Inconvenient and dangerous

Easy to level and sturdy!

Hi! We used this for a 10 frame bee hive. It is sturdy, and well made. I definitely recommend this stand. Thank you!

Good design, super easy to put together. Just a bit expensive.