General Purpose Pain Spary Gun with 1-Quart Canister and Fluid Control (Campbell Hausfeld DH420000AV)

I ordered one and it came damaged. I requested a new one and they send it right away. The new one work so well and it was easy to use! I’m actually very surprised, it worked well to paint exterior walls. I just had to thin the paint a bit. Overall it’s worth the money.

This worked extremely well with latex paint. I set the compressor to 50 PSI, I didn't need to dilute the paint and it sprayed on very well. It clogged up pretty infrequently, but it was easy to clean when that happened.

Purchased this to spray latex paint on some outdoor hunting blinds. Works pretty well, as far as coverage, but it does use a pretty significant amount of paint. I do thin the latex a little, so I can extend the coverage. All in all, it's a pretty good tool for what I'm using it for. I'm running it off a generator and a 2.5 HP compressor. Cleanup's not too bad.

Not easy to workPay very close attention to directionS!!Clean thoroughly after use or you will never be able to use again!!Glad we bought the cheap one...

Worked great when purchased. Tried to use yesterday. No air coming out of the gun when nozzle was pressed. Apparently the air set screw was jammed, On trying to remove this brass screw from the aluminum housing the head of the screw broke off. This brass screw was totally stuck.Had to trash this and ordered a different model (Astro Pneumatic Tool 4008 Spray Gun with Cup - Red Handle 1.8mm Nozzle)with a mechanical screw. Hopefully this will work better.

I used this paint gun with the PORTER-CABLE PCFP02003 3.5-Gallon 135 PSI Pancake Compressor which only has 2 cfm.It worked well. Although the compressor did kick in, it recovered quickly. I used it on some difficult parts of my deck railing. The gun covered well and was easy to use. I used latex and thinned it 10% and strained the paint.You must be careful cleaning it, even though I sprayed the gun with lots of fresh water right after spraying, the tip still needed cleaning.It is nice to have a paint Gun that will work with a small compressor....

First I'll start by saying I was spraying cabinet doors with primer and base coat both water based.At first it took awhile to get the thinning amount down and then it would spray great once I found the right setting .But stop spraying for 1 minute and it will not spray the same again. Take it all apart and clean it , sprays ok for 10 seconds and then acts up again.Lots of time chasing perfect settings just to be disappointed . Wasted lots of paint and hours of time just to end up rolling them

Once you get it dialed in its great. I stained and poly’d all the hand made doors in my house. And also redid my wifes Grand mothers antique dining room set.

I use these exclusively for latex paints. I use the external mix cap and it produces a great finish. I'm currently spraying Benjamin Moore Exterior latex which is about the heaviest fluid I've ever sprayed and it produces a great finish at 40 psi.It doesn't have an easily adjustable spray pattern but you can control that with fluid amount, pressure then adjust your distance to your workpiece.This is my third, my previous ones got damaged when knocked off the bench, or like the last one, I sprayed a bleach mixture through it to sterilize a large area not thinking about the corrosive qualities of bleach. It worked great then the tip etc corroded and it was no good for paint any more :-(. (so don't use it to spray bleach! haha)

Like.

Work well but as no air regulator. Work also with tankless compressor for better results. Made in China which my original one was made in US. Overpriced in comparison with other brand

I was send a very used one with paint residue all over

Like it.paint the fance