YOTOO Engine Cylinder Hone Deglazer Adjustable 1-1/4" to 3-1/2" Diameter with 3-Piece 2" Long Stones 220 Grit

This is not a professional quality tool, but for the price I did not expect that. It did what it was supposed to do and deglazed my 90cc motorcycle cylinder. For the price I am ok giving it 5 stars.

When I got this I wasn't sure if it was going to be good enough for what I needed. But once I received this and watched a few videos about how to use it I was able to use it with ease. I used it to hone the cylinder of a motorcycle and everything worked perfectly once I was finished.

I used this hone for a craft project. Honing the inside of ~2-1/2 inch long pieces of 3" copper pipe. It did a good job on four pieces, cleaned all the oxide off and left them shiny inside. But some corners of the honing stones chipped away, and two of the three stones have cracks in them although still bonded to their base pads. I don't think it is going to last a long time.

Durability could be better.

Perfect for small engine work i have used it multiple times helps hone cylinders

Not worth 5 cents! This is what the item looks like after less than 20 seconds of use! Used clockwise the shaft unscrewed. Screwed it back in and used counter clockwise rotation the head screwed off! With this tool you DON'T get what you pay for. As far as ratings: 1. Easy to use until it breaks. 2. Not worth a dime. 3. Durability less than 20 seconds!

Couldn't find the right size tool locally so I gave amazon a shot. Arrived on time and the quality was great. Great value for an item I may only use a handful of times

Have not had a chance to use this tool , mower engine on back shelf till spring . Frosty

Très bon produit. Très satisfait!

Parfait

This broke within the first 5 minutes of using it, I rewelded the wire part back together and it worked for another minute then snapped and frayed entirely so I gave up and attached the drill to the other end of the honing part and turned my drills clutch to a low setting. It did a terrible job adding new cross hatching to the cylinder and I only did one bore / cylinder and the stones are so rounded over and worn down (I did use lots of oil when I honed it) and I doubt I can use it again without blowing up into a million pieces.Spend the extra money and get a dingle ball hone in the size you need, it'll save a lot of time and head ache.

The hone is poor was poor quality and the stones broke almost immediately. Not worth the money.

I had to add an extra but to the threaded shaft to stop the adjuster from hmbacking off when I used it. Also the included stones were too small for my use case (78mm bore snowmobile cylinder). I purchased some 4" stones from cdn tire and they did a much better job at not getting jammed up in the ports.