YonicoCabinet Door Rail and Stile Router Bits Set 2 Bit Bevel 1/2-Inch Shank 12247

Item arrived on time and was packaged well. The two bits were in a nice wooden box to protect them from damage. Well worth the money. I would highly recommend.

We had to fabricate fridge panels and the bits worked great. The cost of the bits was very economical and the cost was passed onto the client.

excellent what can i say for the price i payed for two bits, i just did four raised panels cabinet doors this weekend past and man did they came out well the joint is well tight fitted so you dont need to use a whole lot of glue. buy and you wont get disappointed worth the money recommended for pro's and diyers alike. update these bits dull very quickly after those four doors were made went to use the bit again and man were they dull, i guess u get what you pay for as the saying goes. i will pay a little more well almost double the price and go with kempston router bits they are quality

My customer liked the look of this cutter profile, so I gave it a chance. The cope and profile make a really nice joint. For the price, I was expecting these to be worn out after the project I bought them for. I made 20 kitchen cabinet doors and these cutters have many more doors left in them.

Yonico is a god sent tool company. I can vouch only for their router bits. Amazing prices for quality tools. These bits cost about a third of the big names bits and are comparable in quality. Well maybe not but 3 of these will most likely out last one of the big name brands. So its obviously more feasible to shop yonico. This set in particular i used to make red oak cabinet doors. Worked as it should. I use 3/4 lumber so all i do is lower each bit 1/16 below the router table top rails and stiles match up perfect. Not worth their weight in gold but definitely a great product.

You can in fact make a decent rail and stile door with a $40 set of bits however be prepared to spend some time with the set up. Using the bearings on the bits to control the depth of cut left me about a 1/32 gap on the face of the joint. Seems like the slot cutter is a bit long or the bearing on the stile cutter is too big. To compensate I held the router fence out from the bearing on the coping bit to shorten the tenon and all good. MAKE A SETUP BLOCK! You get what you pay for in this instance for sure.

Me agradado bastante, con sólo sostener las cuchillas en la mano se nota su calidad, esto en el peso y en sí las piezas se ven muy bien Fabricadas, exelente inversión, no me arrepiento.

For the price, they're not bad; however, if you want accurate/consistent/clean cuts...go elsewhere and spend the extra money.I have a Bosch RA1181 and DW618PKBuilding cabinet door frames I would consistently get splintered rails/stiles regardless of router speed. The bits are not sharp and the fit between frames is very inconsistent.

good quality. Love it. I think, i by more from bestgle

Great product, good price, quick delivery. Thank you.