5 Pcs Semicircle Carbide Oscillating Multi Tool Blades Universal Compatible with Bosch Chicago Craftsman Dremel Makita Milwaukee Porter Cable Ridgid Ryobi Rockwell XG8561

This works great, but no matter how steady I hold it in the grout line, I still get chip out on 1/8" spaced tile. Luckily the new grout covered it up. Still well worth the cost.

they are usable but not a great buy only if your dollar conscious. you will all of them to complete your job. i was expecting a bit more durability. they are ok .

Used these on a masonry project to cut clay and stone bricks, trim mortar edges, and shape brick veneers. At 1/4th the cost of similar products from big box brands, I expected these to be worn out quickly after using them up on a couple of the harder cutting surfaces. Originally intended to use these for non-detail cuts to save my more expensive blades for the detail work. I was blown away at how effective and resilient these were. Even after cutting for a couple hours, the grit seemed to maintain. Cut lines and bite were consistent throughout too.As with any grit blades, they do not last forever, but they seemed to last as long as the more expensive versions and performance seemed about the same too. Overall 5/5 stars, when I need more I will reorder these.

I was removing grout from my shower so I could regrout it. The abrasive surface on these blades did not hold up for more than 10-15 minutes before it was gone. Would not buy again, and tossed them in the trash.Customer service contacted me and made this purchase right. Nice to see someone stand behind their products.

I bought this set for a DIY tile job. I needed to clean the thin-set mortar out of the tile spaces before grouting. This was a mosaic tile floor, so there was a lot of tile to clean out. One of the blades did the job, but was pretty well worn out when I was done. It was certainly worth the money to get the job done right.

These are great for cleaning grout lines. They even melted the plastic left over from the leveling clips. I hoped they would also be good for tile corners but the range of vibration on the saw didn’t support that. I’m sure the blades would have worked otherwise.As for longevity, I consumed the coating on one blade about 1/2 way through the grout lines effort on a 3x5 foot shower. The second one did not show the same level of wear after I completed the job. I’m not sure if the first blade’s coating had a flaw or just had to work harder.

I had a project where I had to remove LOTS of grout in a tile wall. I figured for the price of these blades, what the heck. I got the 4 pack for what 1 blade costs at Home depot or Lowes and those don't last that long. I would just use them and toss them. I was suprised at how well they held up. I purchased a second pack figuring I would need them but, to my suprise, I only used 3 of the origional pack. I only changed them because they slowed down some at their end of their life. One warning is they are NOT able to cut ceramic or porclean tiles. I have NOT tried to use them on brick or stone or cement.

I use Tham for cleaning out grout.Dare work well.

El largo de una cuchilla fue muy importante para corregir el marco de una puerta, me ahorro mucho trabajo, me evito tener que quitar la puerta y el marco, además se redujo el tiempo de reparación a no más de 1 hora

Buen producto, pero la verdad no he usado otro marca o herramienta del mismo tipo para tener una referencia de comparación pero cumplió termine el trabajo

Great value for your money doesn't mean they're cheap. They fit perfectly with my Milwaukee M12 oscillating saw. Go slowly for best results.

Great product for the price. Works just as well as the brand name ones I've used in the past. Haven't used it a ton, so I'll see how the durability is in a few months.

Grout removal