Windslayer Cover Housing Frame Case for GO Hero 5 Hero 6 Hero 7 Black Video Noise Reduction

Just used this product over the weekend at what I thought would be a pathetic substitute for my external mic/windscreen I usually use for my Go Pro. I was AMAZED at how well it performed. I was in VERY high winds and although you could hear minor "puffage" from the wind you can still VERY clearly hear all voice. None of it was drowned out AT ALL by the wind. Not even for a few seconds! Very impressed with this product. My external mic still gives me slightly clearer voice but its windscreen does no better in my opinion than this little gem! And........it fits over the Go Pro housing after you place the camera inside! Buy now!

Amazing solution for reducing wind noise! The Taisioner Windslayer Cover Housing Frame Case for GoPro does an outstanding job of minimizing wind interference in recordings. It fits perfectly, and the design effectively shields the microphone without obstructing audio quality. A must-have accessory for outdoor shooting, especially in windy conditions. Highly recommended for GoPro users looking to enhance their audio capture!

Works well! Cuts down on wind noise, my only issue is the extra size it adds, looks kinda goofy. But function over form!

I have used this windscreen to film roller coasters, e.g. Expedition Everest and Incredicoaster, with no wind noise. I purchased this item in April and waited four months to write this review. Initially, the windscreen is a pain to put on but you get used to it quickly and it seems to loosen up enough to easily put on but no wind noise. To change batteries, I just pull back the one side of the windscreen and it takes seconds. I thought for certain that I would have ripped this by now but it is much more durable than expected. Go to the 2 minute mark on the video when the roller coaster starts to move. You will hear no wind noise.

This is a pain to work with, unless you remove the door to the USB slot and manually cut a hole in the foam. I'm not sure why they didn't already include the hole. They added one for the on/off and start buttons. If you don't take those steps, you are going to spend several minutes each day just removing the foam to recharge your camera. That will eventually take it's toll on the foam. If you do take those steps, then you can keep the foam on constantly and leave your camera attached to your support device. It does work. It will clip the "peak noise" of the wind, but can't remove the sound of wind itself. It acts like a high pass filter and saves me time in post-production sound filtering for nature videos. I gave it three stars primarily for not thinking ahead and adding the USB hole and the user experience. I read the negative comments and was concerned about the "it doesn't work" and "it doesn't fit" comments. I think they are both related to users who aren't using the camera enclosure with the foam. If you put just the camera in the foam, it doesn't fit at all and it will move around probably making more noise due to the foam rubbing against the mic. Having it in the enclosure fills the foam and actually fits tight. One other thing is that, if you use the top/start button to stop your videos, you're going to get a nice loud crackle of noise as your finger slides against the foam to get to the button. Because the mic is right next to that button, I doubt there is any way to mitigate this.

Works perfectly

Good price ,quality ,works well on windy days do alots of filming on my tours(bicycle). That's the wind noise out

This product is extremely effective at eliminating wind noise on my gopro hero 7. I use it for mountain biking and there is almost no noticeable wind noise even at 30+ mph. I added some pieces of the fluffy side of Velcro to the frame of the camera which helps to further deaden excess noise. The product does not feel as durable as I had hoped/expected, however, it has held up quite well on the chin bar of my helmet.