2-Piece Milling Vise, 6" Jaw Width, 2 1/4" Jaw Height

evidently CME switched factories that these came from but not the item number. they changed the ad picture after i started to ask questions about the one they sent me. the one i thought i ordered had serrated jaws and a bolt mounting kit the one i got had smooth jaws and the jaws were deeper?, no bolts. CME sent me mounting bolts that fit something large, ok thank you, but after the job was done. the wrench/handle they sent fit something else much larger not the vice they sent, i was told they would make an adjustment, this has not happened. they did offer to accept a return, i needed this vice bad for a job so i made it work.... so the vice is decent for an economy vice. it did not exactly fit my RF30 mill-drill i assume it will not fit the china knock-offs as well., i made it fit close enough to get the job out. i did not have trouble with lift but i could see this as a problem on smaller, thinner parts. i'll need to make a set of different jaws. american standard jaws will not fit or adapt. so the vice is a 3 and the transaction is a 2. use an adjustable wrench instead of the dust collector handle.

This is a usable vise for my PM 25 milling machine. You get what you pay for in most cases and this is no exception. I took it apart cleaned it. The bore for the movable jaw is terribly pitted on the bottom inside of the bore with a very rough finish on both male and female surfaces. I mean it's going to work, it's going to hold parts and for the money I suppose you can't complain too much. Would I buy it again yeah I suppose I would only because I couldn't afford to spend 500 bucks or something good. EDIT*** after two uses I can clearly and accurately state that this vice lifts your work a lot, and makes it difficult if not impossible to get accurate milling results. Not even is useful as I thought it might be

Cost was awesome and it worked great.