Senco DURASPIN DS230-M1 2" Auto-Feed Screwdriver Attachment 9Z0021N

I read quite a few mixed reviews on how well collated attachments work. Some people mentioned that they were not able to get them to work without jamming and others mentioned that the depth is never consistent.Well I received this attachment today and had to try it out before I begin to drywall my basement. First of all, I’m impressed with the quality of the attachment. It feels well made and it’s extremely easy to attach to my makita screw gun. Just take the bit holder off the makita, attach one of the included bits from the Senco, place the magazine over the tool, and twist the collar to tighten.Next you need to adjust the tip of the attachment to the size screw you are using (anywhere between 1 to 2 inch screws). Run a screw in and check the depth. The first screw I ran was on the right side of the board in the picture. Went too deep so I adjusted the fine adjust dial out and ran another test screw. This screw was just a little too shallow. Two more clicks deeper and the depth was perfect.After I adjusted the tool I ran about 14 screws as fast as I could and WOW! This attachment is very smooth. I ran every screw down to a consistent depth and most importantly it did not jam a single time.I’ll be running thousands of screws through this attachment in the next couple months so if anything changes I’ll be sure to update this review. For now, it’s well worth the investment in time savings alone.

Can't give much of a review, We bought this for our Makita screw gun. IT DOES NOT FIT MAKITA. Called and asked how to install it and was told this is the wrong model.

It fits my Makita model perfectly, and it runs flawlessly. I've ran it on an entire house that we sheetrocked and this is probably the best 90 dollars I've spent on a tool. If you're hesitating, get it!