DK2 Universal 84-Inch x 22-Inch Hitch-Mounted Winch-Driven Snowplow Kit

After its mounted on the Gator it rocks. Pushes snow well. Blade is tall enough snow does not spill over the top back onto what you want cleared. Left, right, straight easy to hop off and angle the blade. Remote works as intended. Now. The power cords from the battery to the winch are probably 10 feet too short. Why skimp here when you have a good product? Not smart. No way to hide the wires underneath a UTV and forget about a pickup. There is not enough wire and the blade end connectors are tiny. Not sufficient for an automotive size battery terminal bolt. All in all pretty good but they did jack the price 60.00 when it snowed. Seriously ?

Plow is a fine unit, instructions suck but its pretty easy too figure out. 4 stars because I had a hour one way too the local xpo terminal too pick it up because they quote "didnt have a lift gate truck available for the next week or two". Plow is fine, Xpo freight is a joke

Phe plow itself is great and works well for home and LIGHT commercial, but the winch and strap are built very cheaply. My strap broke after 4 times plowing.

If I were going to take away points: it hangs pretty far in front of the truck. The holes to mount the stiifeners were EXACTLY where my tow loops were on my front hitch, no alternative. It doesn’t seem to backdraw well..me? A PLUS: It comes with all bolts in place, washers and lock nuts on, not a bag of bolts and a bag of nuts, washers for you to aort through.. The assembly manual leaves a bit to be desired...common sense and perseverence needed, along with a full set of wrenches. My tips: 1) When putting the wheels on, there is a left set an a right set..test mount, and check that the locking pins align with the holes in both UP amd DOWN positions. 2) It is easiet to mount the rubber snow deflector by temporarily pinning it in place at each end with the wands. Note also that one of the three hold-down strips has two holes in the middle...this aligns with the two in the middle of the blade. The other two metal pieces don’t have bolts in one end...that’s where the wands will go permanently. 3) The saucers umder the blade are supposed to act like runners, so the blade doen’t scrape all of your gravel away. They were a bear to work with to set the blade height at 1/2”. The upper Nylok is BIG and TIGHT. I needed a 15” crescent wrench to turn them, but then the saucers turn with you! The tip is that there are flats at the base of the center screw...a welded nut...put locking pliers on that, loosen the nut just under the mounting plate, and adjust the Nyloks to give you the 1/2” lift to the blade. Then tighten the nut under the mounting plate to lock it all at that setting. 4) It is easiest to REMOVE ALL of the bolts they have pre-positioned for you, so they don’t act as stand-offs when installing that piece.

The plow is decent for the money. The assembly instructions are very difficult to follow. I had to go back and change a few things based on the picture and not on the instructions. The only thing that is a bit bothersome is the plow sit really low on the receiver. You will bottom out with minor dips in the roads or going in ramped driveways. My truck sits high and its still a problem.

This was simple to put together and install! Super sturdy, definitely worth your money, it is quite heavy so it took a couple people to install.

I was impressed on how well it was packed for shipping. Easy to assemble . Well constructed materials and no missing parts. I would recommend this plow for home use .

Very great quality