Lockitt Posi-Tap 6pc pack #605/6 16-18 awg Blue

I wanted to replace the dash speakers in my 2016 Toyota RAV4 Hybrid with the JBL sound system. In this configuration, there is no commercially available harness that matches the wiring plug.I purchased 3.5" Kicker speakers from a well-known electronics site, and they came with lead wires that were pre-stripped at the ends. After unplugging the old speakers, these Posi-Tap connectors enabled me to tap into the positive and negative wires just behind the plug, then connect the lead wires coming from the speaker. Wiring up each dash speaker in this manner took less than five minutes and required no splicing or crimping, with minimal impact to the wires if ever I wanted to remove the Posi-Taps.I encourage anyone in a similar situation to strongly consider these connectors as a solution.

I used these during installation for my 11th gen Honda Civic. Since the car did not come with fog lights in the US, I purchased aftermarket fog lights. I used these to tap into the BLUE driver side headlight wire to power the fog lights.Note: I had to cut a small slit in the head light wire due to these not penetrating the wire to access the raw wire for power. I tried several times by lining up the blue wire and screwing down hard, but it wouldn’t cut through the wire. BUT once this small adjustment was made, these made life easy and worked flawlessly. I recommend them for sure!

Will only use these for wiring fast and easy and last. Had done wiring for my trailer lights with these decades ago and still going strong

These are simply screw on and forget about them, great for all auto electrical needs.

The most expedient way to tie into another wire. Very effective as it is almost impossible to not do it correctly. They are also reusable. I keep several on hand. Give them a try. In my opinion, they are worth every penny.

In the right situation this is an easy way to tap into a wiring harness with minimal intrusion.

It's just about the only connectors I use.

Worked as needed