V6 Dual Color 2 in 2 Out Extruder for 3D Printer 1.75mm Filament Multi-Extrusion V6 Bowden Hotend Kit (12V,Silver) 0.4mm Nozzle

Didn't work on my setup

Been trying everything to deal with this clogging issue I have. It gets going looks good the next thing I know my piece is ruined, my filiments all clogged up. Idk if it's me, my machine or if the parts are incompatible or if the parts are bad. I'm getting nowhere. I get 1 piece then it gets me 1/2 piece, then it's clogged again.

Its the cheapest chimera out there that I could find, it actually is what I ordered for that price. Now the issue comes with the fact that the screws used to hold the throat were easily stripped, causing me to use all 4 spots, and even then the left hotend throat didn't stay in all the way, it wiggles easily. The nozzle and throat easily screw and unscrew each other. If the block is held in place and I twist the throat the nozzle unscrews some. I haven't printed with it yet but it seems to be overall acceptable in condition and build. I'm using a direct drive on the right, Bowden on the left. I'm hoping this will workout. I'm running it on my Ender 3 mod. Overall only use this if its in an enclosed and undisturbed spot on the hotend carriage and it should be safe. No hard bumps to the hotend.

Item arrived. It looked ok at first other than the hotend set screws are on the back instead of the sides like the picture shows. Installed the unit, and was VERY IMPRESSED that it actually has all metal hotends. But there's a problem. The Unit is misaligned internally, so it gets JAMMED all the time. And heres the problem. It works for a few seconds, but after the 1st "retraction" when it goes to put filament back in, it can't. And it get jammed in a part with no heat, so it literally has no way to get past it. This requires pulling out the filament, cutting it off, and reinstalling it. I've tired rebuilding this thing several times, all with the same result. The one i received is just misaligned internally, and can't be fixed by me.. I'm just sending it back and will get a mixing nozzle this time i guess... I really only wanted to print PVA dissolvable filament for support.. :(

Finishing seems fine, the components seem good. However, I bought thinking it would be one design (the grubscrews that control the nozzle height) being on the side, but it is in the back.

No instructions, mounting screws, or plates. No template to help design something. To mount to.