45 Degree Lock Miter Router Bit 1/4 Shank, Newdeli 1/2 Stock Joint Woodworking Router Bit, Suitable for Furniture Oblique Tenon Interface Making (90-Degree Tenon Joint Woodworking)

It gives a clean cut.

Works well. Proper setup is key

Very difficult to set up on your router table and yes you need a table. Have lots of scrap material on hand to make test cuts ,you will need it. Once you get it dialed in it does work.

Great tool to work with.

Once I figured out how to set up the bit, then it worked pretty well. However, it seems to have a lot of tear-out. I hope that’s the correct word. There is tare along the edges of the cut. So, impossible to use with plywood, even Baltic birch. I did use it with poplar and the tear out was less, but still there. 3 stars for the design, lowered for the sharpness of the blade. Also, the cut is a little complex, which increases the chance of errors in the cut. Not saying don’t buy. Just saying you may be a little disappointed.

Just showed up to late to through in router table will try tomorrow

Great quality and holds a sharp edge

Adjusting the but was tough to get right to begin with, and I’m pretty experienced with woodworking. It tore up the 3/4 cabinet grade plywood. Couldn’t get a good straight edge with this on my router table. I bought it and didn’t get to the shop for almost a month, then used it yesterday and spent 2.5 hours messing with it to make drawer boxes. Wound up scrapping every one of the cuts. First time I’ve left a bad review for anything. I have a 2.5hp router and it bogged it down even at higher speeds. Missed my return envelope by 2 days due to work commitments. Good thing it was only $12. I guess you get what you pay for.