ASSORTS Mini 2"/ 50 mm Steel Vice Vise Work Holding Engineering Machine Tools

This little vice is pretty high quality and the machining is decent the only drawback is that it doesn't fit a lot of smaller micro or table top metal lathes. I'm actually using it on my SL 1000 umat. I drilling the mounting holes larger In vying appropriate sized metric fasteners which I had to turn the heads down to get them to fit in the newly drilled holes. All in all it works out fine. It could have a better handle, the 2 little threaded Kept coming off so I ended up putting a few dabs of thread locker and it's fine now

good quality for the price would not hesitate to reorder

It lineup good enough. Jaws are straight with minimal play. Supplied hardware is junk and not usable. Excellent hobbyists grade vise!

I bought this to use on my Proxxon X-Y. table The spacing of the hold down bolts fit grooves on the table perfectly. The fit and finish of the machined parts are excellent. Much better than I expected. The only downside is the lead screw for opening and closing the vice jaws tend to bind slightly. But not so much that it becomes a problem. (That’s the reason for 4 stars, not 5) A small amount of lubricators should correct this. A good value for the price.

Down side is, when you get yours, you'll have to take it apart. There is machining schmutz on every surface, and every nook and cranny. You'll have to clean out every hole that was tapped, every surface; any and all machined surfaces. On my vise, Right towards Maximum open, the vise binds, and has to be overcome, so not completely smooth operation. Overall, not a bad little vise, will do what I need it do, but I'm a little disappointed in the Value. Different parts of the vise seem to be made by people with vast differences in machining experience.