MiiCoffee SSP Multi-Purpose (Unimodal) Espresso Grinding 64mm Flat Burrs (Red Speed Coated)

مذهل و رائع جدا

I’ve just upgraded my espresso machine from a Quick Mill Silvano to a Decent. A part of me wanted to upgrade my modified doserless SJ to a lower retention Lagom P64, but honestly, that felt like a costly cross-grade benefiting from really only better burrs and workflow. I’ve decided to save my money and go the route of less resistance by buying these SSP multi-purpose burrs and taking the time to align them. The photos show the alignment of the rotor’s burr, but I assure you the collar burr looked the same; just can’t find my photo taken a few months back. Anyways, I’ve had the chance to go through roughly ~10 lbs of coffee through this setup, and have found the body is not as thick as factory burrs, but a bit more pleasant for me. If you’re into lighter roast coffee like washed Ethiopians, this is the burr for you. I really enjoy this setup for my daily routine. Now, milk drinks are still pretty good, but may lack the body some may sought after. To me, for espresso drinks, I find this burr set really shines for espresso on ice, and espresso and tonic.

Transformed my Super Jolly. I had stopped using it for filter (was using hand grinder instead) but with these burrs it is really fantastic. So clean and clear.

I put these into my DF64 grinder 2 years ago now, and the difference was noticeable immediately. The grind is more even with fewer fines, and the coffee I have made with them over the last couple of years has far more clarity than the stock burrs. It was a struggle picking which burrs to go with, and I'm happy I settled on the unimodal since I make both espresso and filter often, and these handle everything sweet as! Installing them was quick and easy - if you have the patience, you can level them perfectly with shims too. Would 100% recommend if you want to level up your coffee without spending thousands on a more expensive grinder or machine.

Las compré para reemplazar las muelas en un molino ANFIM Cody, la medida es correcta para los barrenos para los tornillos no coinciden, por lo que no me sirvieron.