Happymodel Mobula8 85mm Micro FPV Whoop Frame for 2 inch Props 702/703/802/1002/1102/1103 brushless Motors 1-2S Micro FPV Racing Quadcopter Quad Frame kit RC Drone Frame 2Pcs

They’re light, but not too durable…especially in winter. I don’t know how many frames I’ve broken outside. But they do tend to protect the expensive electronics. So if something needs to break I’d rather sacrifice a frame.I’ll keep buying them.

The post between the motors and duct like to separate with minimal impacts. I live in S. Florida, so the cold isn't an issue. One of the few 85mm frame that have a three screw motor mount.

The media could not be loaded.

I 3d printed a canopy and hooked up some parts I had to make a 2s whoop with this frame. It was much heavier than I'm used to for an indoor whoop, so It got it's fair share of test crashes. Over all it has held up very well. I may have over tightened one canopy screw, because one of those standoffs broke in a crash, but that seems to be the only damage. I only used 2 screws for each motor because the holes in the frame seem a little too close together, and looked like it was putting stress on the motor. The 2 screws have held just fine though. Overall Seems durable and build a fun whoop with it.

I normally give a lower review for misleading titles, but it isn't claimed to be CF anywhere else, the pictures don't look like carbon fiber, and the weight is correct.They are very flexible when bending the propeller cages, but there are stress points on the pins and cage where it's thin connections at 90 degree angles. I'm not sure there's anything that can be done about that, though. Any sort of ribbing or other type of reinforcement would prevent proper installation of the components. They come in a solid corrugated cardboard box with bubblewrap and neither of mine came damaged.Seller should remove erroneous materials in title. Otherwise, these are sufficiently good nylon frames.