Tube Pipe Tubing Beader Tool Bead Roller Intake and Intercooler Piping Fits 5/8"

This bead Roller works amazing. Great value too

Perfect for aluminum intercooler piping and aluminum coolant ends (custom water necks and radiator ends).

Worked great on aluminum. Wish the handle attached to the tool a little better but overall did a fantastic job.

It’s not the products fault but don’t try to roll the bead all in one go, you’ll start twisting the handle flange. I used this to roll beads on my turbo charge pipes and it worked great once you get the hang of it.

Worked great and rolled beads on intercooler pipe easily. Worked fine on the pipe right out of the box but I found that annealing the pipe made it even smoother as did a little WD-40 on the pipe and rollers. TO anneal it I just marked it with Sharpie and them hit it with a propane torch until the Sharpie disappeared. Easy.

Gets the job done. Had trouble blowing my charge pipe off under boost because I never rolled it. Also 9/32 socket and ratchet/drill works better than the handle if your vise is in the way.

Rarely will I review a tool and immediately review it. But this bead roller, it’s the best tool I’ve purchased in years. Easy to use, excellent quality, great storage case it comes in . It’s going to come in handy when making air intakes, charge pipes, coolant tubes. I wish I could give it more stars.

This works OK. If you have anything other than a very small vice it is difficult to work with because the crank will hit the vice. I had to adapt a quarter inch socket extension to use it on my vice

Works great, slightly challenging as you have to hold the pipe so it doesn't go sideways, once you get the hang of it it's an excellent tool!

Hizo falta el maneral

Rolls 0.080 aluminum tube very well. Did intercooler piping no problem.. would have got five star but the handle kind of sucks. I welded mine on