8MILELAKEBlind Inner Bearing Puller, Hole Remover Extractor Set, 16pcs Blind Hole Collet Bearing Race and Seal Puller Extractor Kit, Slide Hammer Tool Set

All the size for project, very durable, great quality, ease to use , great value and buy thanks

After pulling two bearings in a tractor transmission I knew this was a good purchase. Easy to use--threads and steel are good quality. The amount of purchase on the race seems better than other kits that only have the narrower-shaped expanders. Yes, the slide hammer could be longer and heavier (as other reviewers have said), but it's appropriate for what the kit is intended for. It's not an axle puller, and sometimes a B_H isn't the right tool for the job. Only problem was that the "T" pin in the slide hammer end came out--not enough to give lesser rating.

Had to exchange it because of obvious manufacturing defect. However they are very useful and I don’t know how I lived without them.

Works okay if the whole bearing is there if inner race falls out It would not work and need a longer slide shaft

Bought this to remove the bearings inside my dodge 208d transfer case. Was able to remove them all using both the slide hammer and the 2 leg puller. Would honestly say Im more impressed with how well these worked. Only thing I did notice was the puller doesnt always like to stay perfectly straight up once you start putting pressure on the bearing, but was mostly able to help assit it by holding it in place while tightening. Other wise the build quality on this set is pretty nice and stays true with each piece

Purchased to pull a blind pilot bearing during a clutch replacement. This tool is poorly designed and of poor quality... slopped shoulder doesn't allow the puller to get a good grip on the bearing, causing the puller to slip out. Puller deformed without making any progress on removing the bearing. The slide hammer seems okay. Overall, a complete waste of money. I ended up using the bread technique which had the bearing out in under 5 minutes. If you need a bearing puller, go with a different design and stay away from this.

This is an incredible set for the price that I paid. Use them to get out some bearings from a hub assembly. It was very difficult to pull the bearings had to heat up the hubs and then freeze the bearing race to pull them out the tools never failed and ultimately successfully pulled them out.

A most have if you working on transmission. Never realized how much easier it is to pull a blind bearing with the correct tool. Been rebuilding manual trans for a while and this is a must have for bearing pushed into the case. Most have the tool completely centered for it to work. Took under 2 minutes to pull all the bearing out the case. Slide hammer is a little on the small side but makes it usable in small access areas. If you have another slide it screws right in, so no worries