Upgraded Fuel Injector Tester and Cleaner Kit with 8 Pulse Modes 4 Injector Cleaner Adapter 12V/5V Output Power Modes Short Circuit Protector Clean Two Fuel Injectors Simultaneously DIY Cleaning Tool

Used this on a Triumph Tiger 955i. This really does work and allows you to clean your injectors with just the kit and a can of spray carb cleaner. Don't get any on the case of the unit though otherwise it will dissolve. Also don't look at the green LED as its sooo bright. The instructions are hopeless so you will need to check out you tube on how to use this type of gear. I used mode 8 to actuate the injector constantly and then I had both hands to hold the injector and the can on the adapter.

Very easy to use.Tested the continuity of my Kawasaki z750s injectors with them fitted.Then I took the fuel injection arrangement off the bike and was able to get them all checked working with carb cleaner. It's a good job done inexpensively.

The unit works well but the injector holders won’t take much pressure of the holders wasn’t drilled all the way through but there was an extra one in the packet. I would say it’s fair for the money but it’s not perfect but it will work and it does pulse the injector, which is very important.

Cleaned the fuel injectors on my ZX6R , using this was the easy part.

sono molto contento con questo Tester per iniettori! L’ho utilizzato “ a secco” senza smontare i iniettori, con modulo uno ( un impulso a 5 V) e due (50 impulsi a 5 V).

Injektoren am Fahrzeug sind sehr empfindlich und das bloße wechseln der Kupferdichtungen sollte schon mit größter Vorsicht gemacht werden. Ich habe das nämlich bei meiner E Klasse S211 220CDI gemacht und habe mich wirklich nicht getraut die Spitze des Injektors mit Injektorenreiniger/Decarb zu besprühen oder mit Bremsenreiniger... das würde aber auch nicht unbedingt viel bringen, hierzu muss das innere gereinigt werden. Und genau dafür eignet sich dieses tolle Set. Ich habe Videos dazu auf Youtube gesehen und hätte ich das vorher gehabt, dann hätte ich meine Injektoren vor dem Einbau hiermit gereinigt. Einfach ein Injektor in den passenden mitgelieferten Aufsätze stecken und mit einer Dose Injektorenreiniger verbinden. Durch das einschalten des Gerätes (die Kabel rot und schwarz steckt man an die Kontakte des Injektors, dabei egal welche Farbe wo drauf) und simuliert das schließen und öffnen des Injektors unter Druck. Dadurch sprüht es ein paar mal, bis ein feiner Nebel herauskommt (am besten mit dem Smartphone aufnehmen und Zeitlupe abspielen). Super Teil, sehr schlicht!

Funciona perfectamente, limpia el inyector 100%

It was a while ago that I used this, and I don't know to what degree it might have cleaned my injectors, but at the time it was reassuring to see that something on this heap of junk actually worked. Since the spring of 2022 I have been slowly rebuilding this $500 1989 POS that had been sitting in a cornfield since 2003. Rodents had eaten all the tasty parts in the engine bay, the roof was rusted through, the interior trashed, the starter motor was dead, the fuel tank full of tar, the tires flat and rotted, and no title to boot. What was I thinking when I bought it? At first, the only thing that I knew actually worked was the AM/FM/Cassette player. The second thing I got working were the injectors, and that is thanks to this little gizmo. And now, nearly 4 years (& many $$$) later, I am getting close to starting this thing up.

Bon produit