LE LEMATEC Air Compressor Regulator & Flow Control Valve with Pressure Gauge - for Pneumatic Tools, Spray Painting, Tire Inflation, 1/4 NPT, 0-150 PSI

Works really well for my set up! No leaks, easy to install and use!

Accurate pressure control and solid metal construction. Keeps my spray work consistent.

I have a allot of Kobalt brand power tools and I had recently purchased a Kobalt pressure regulator and it felt cheap and was only rated for 90 PSI. So I replaced it with this new regulator. It’s much better and cheaper priced than the Kobalt brand one.

Works well with my setup. Fits well, with good airflow, easy to use and leak free so far. Decent value for the money.

I have 4 of these regulators and they work great. I use them on each of my spray guns. No more trying to compensate for the length of the airline, just set your pressure at the gun and go to work! They hold pressure very well.

I used this for my spray paint gun for automotive work. I followed the instructions and set the pressure with flow on the gun. When you are not using air, it shows the hose pressure. When you squeeze the trigger on the gun you get a burst of higher pressure air, but that is normal, spray paint guns have dule stage trigger just for this reason. You just leave the gun trigger at air output and only go between paint out put and not. Worked just fine and no air leakage around the regulator knob.

Don’t call it a regulator…it isn’t. Basically an open/close valve. The good - it doesn’t leak and does measure the line pressure correctly. The bad - as already stated, does not actually regulate pressure. Cannot reliably dial it in; just guestimate what it is.

Easy to use and it appears to hold low pressures extremely accurately out of the box.