Window Visors Rain Guards for Toyota Corolla 2009-2013, Out-Channel Window Vent Wind Deflectors Visors Shades for 09-13 Corolla

Works great, strong hold. NOTE: *You have to get it right the first time when you apply it, so figure out where you want it to stick and make it happen. If you stick it on and then peal it back off to try and get a better position the sticky tape will lose a lot of hold strength. It may not even work after that. Make sure the surface is clean and has no greasy residues on it and you'll be fine.This is a Dodge Journey Crossroad 2014 fyi. So no matter the year of Journey or trim it will be the exact dimensions I needed. It fits pretty much perfect for all journeys (but other make/modelsto, check product info). On the back door, the window covers barely fit. You have to angle them just right but it will work, once you figure out that sweet spot.

Great fitting worked on my 2020 Ranger perfectly, my windows had no issues going up & setting flush in the window channels, these are bendable enough to work into the channels without breaking them, make sure you clean your window seal with alcohol, then use their supplied adhesion promoter, don't roll your windows down for 24hrs.There are others online, same design that cost more, but if your budget shopping I dont think this is a bad choice as long as it's under the thirty eight dollar rang

You can't complain about getting a good price for a product that works and fits right. There are some things to note tho. The adhesive could be better cut, it is longer than the rain guards so the adhesive shows and requires trimming after fitting. The plastic isn't cut well in some places leaving little plastic frayed edges showing, this can be cleaned up with a razor blade tho. And my main complaint is that they are barely tinted, they are more like a medium gray and very thin so you can see right through them. My car's trim is piano black, so the guards kinda stand out being lighter and see through. The fit however.is pretty good and they are flexible enough to bend to the contours well. For the great price I can't hold these faults against the product.

The visors do not align front to back. There is a noticeable alignment difference between the front and rear visors. It's not huge, probably around a few millimeters where the rear visors are cut lower than the front visors. It's difficult to explain, but I took photos of both sides of my car. They do not align visually. The overall quality is good, and otherwise a nice product.Update: Removed another star after spending time with the visors, I can tell these visors lack clarity. When trying to look through them, they aren't very clear. I've owned similar products in the past and can't remember this being an issue. Clarity isn't a problem on my truck and the visors on it are almost a decade old. But the alignment issue shouldn't even exist.Update 2: My family and I just took a short trip to the beach. Two words come to mind, wind noise. The front window visors create a lot of wind noise. Windows open or shut, the wind noise is there. This may be the last straw.

One of favorite purchases for Jeep. While at work, I am able to leave small crack and not worry about the rain.

Guards work great and actually stick without needed extra tape. I would buy again and recommend 👌

Bought these for our daughter's car, they were easy to install and the directions weren't hard to follow.

They do cause road noise by air whistling by, but they all do in different degrees. I only put them on my back windows on my truck because besides your head the noise is quite loud. They do work better than the ones that go in the gasket around your window as they seem to leak a lot of air making quite a bit of noise. It is nice to crack your windows and not have to worry about rain coming in so my tools can stay a little cooler in the cab. I would buy again